![]() disconnected - USB client can not connect to remote USB Server.connected - USB client is connected to remote USB Server.The IDs are displayed by -list-devices command as shown above.Įach USB server is displayed with a status that can take the following values: = devices and servers in USB Redirector are assigned with unique ID numbers, these IDs help to conveniently connect or disconnect devices, or manage servers in your configuration. Mode: manual-connect Status: available for connection `- 19: FM1083 FORTEMEDIA - Composite USB Device | Mode: manual-connect Status: available for connection |- 1: Flash Disk USB - USB Mass Storage Device To add a USB server into configuration you have to execute the following usbclnt -list-devices It means that if connection is broken for some reason, USB Redirector will re-connect automatically until connected. USB Redirector will automatically maintain a connection with all USB servers in your configuration. To connect to a remote USB server, you need to add it into configuration. Remote USB server address and port number as displayed by -list-devices command. Specific server ID number as displayed by -list-devices command. is one of the following parameters that identify a remote USB server: The name must be enclosed in double quotes. USB device name as displayed by -list-devices command. USB port number as displayed by -list-devices command. Specific device ID number as displayed by -list-devices command. is a combination of one or more of the following parameters that identify a USB device: is a server ID as displayed by -list-devices command. is a device ID number as displayed by -list-devices command. Parameters used in the commands are as follows: List all USB servers and their USB devices currently presented in configuration. Remove specified device from exclusion list.Įnable or disable automatic connection of a single device.Įnable or disable automatic connection of all devices on the specified server. ![]() Server should be added to your configuration first.ĭisconnect a specified device from a specified server. Remove remote usb server from configuration and disconnect all USB devices from that server.Ĭonnect a specified device from a specified server. The generic command-line syntax of usbclnt utility is: All further operations are executed with the help of this utility Command-line Syntax You need to use usbclnt command-line utility for connecting/disconnecting USB devices, it is also installed in your system. If installation completed successfully, the daemon named usbsrvd will be running in your system, it does the actual redirection. If you faced any problems during the installation, please read our installation troubleshooting guide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |